PIAA SMH3 Snow-Melting Heater for Headlights and Tail Lights, Unit and Outdoor Air Temperature Sensor Harness, 12V Vehicle Custom, Road Transport Vehicle Act Compliant, Car Wash Safe, Pack of 2

Headlight Body
JAN: 4960311056652

●This product is a snow melting heater that can be attached to headlights and taillights. This is a simple and highly effective snow melting function that directly applies heat
to the outside temperature + approximately 50℃ using an ultra-fine line heater . (The snow melting function varies depending on the environment. In environments where snow and snow cannot be completely melted, please brush off the ice and snow directly.) ●Low power consumption Only 5W Low power consumption that does not put a burden on the battery! Operates with only 5W per side. ●Simple installation wiring is achieved without using a relay harness. It works just by connecting to the ACC or vehicle width lights. Wiring can be done from either the top or bottom of the light unit, or from the left or right, so it can be installed simply without removing the light unit, depending on the vehicle model. (Depending on the shape of the light, please install it correctly based on the instruction manual.) ●Equipped with outside temperature sensing auto ON/OFF function. Automatically turns on when below 5°C and turns off automatically when above 5°C. Automatically activates when the temperature reaches 5℃. (When connected to ACC) When connected to a position harness, it is the same as above, but it is activated only when the position lamp is lit. ●This product has a 3-year warranty for the sensor harness and a 1-year warranty for the heater unit. ● Compatible with both brush type and high pressure washing type. You can use normal car wash as is. Although it is car wash compatible, rubbing the heater unit too hard or using a high-pressure washer at close range may cause it to peel or break. In that case, please stop using it. We recommend replacing the heater unit once a year. We use transparent tape that does not leave any residue when removed when replacing.